Ledbe SP103E LED Magic Controller
Nadview
The SP103E is a compact, high-stability controller for addressable RGB pixels, designed for dynamic lighting with an intuitive 14-key RF remote and a wide 5–24V input range.
Specyfikacje
| Wejście Voltage | Prąd stały 5–24 V |
| Pixel Capability | Do 2048 XNUMX XNUMX pikseli |
| Supported ICs | WS2811, WS2812B |
| Zdalny zasięg RF | ~20 meters (~65 feet) |
| Temperatura pracy | -20°C do 60°C |
| Wymiary kontrolera | Wymiary: 70 × 12 × 3 mm |
| Zdalne wymiary | Wymiary: 85 × 40 × 6 mm |
| Wbudowane efekty dynamiczne | 358 |
| Zdalne klucze | 14-key RF remote |
| LED Signal Type | TTL/SPI signal addressable RGB pixels |
| Uwaga dotycząca zgodności | Not designed for constant voltage PWM LEDs |
Quick Setup & Use
- Provide DC 5–24V input power to the controller.
- Connect supported addressable RGB pixels that use TTL/SPI signaling (WS2811 or WS2812B).
- Use the included 14-key RF remote to select lighting modes and effects.
- Operate within the remote’s range of approximately 20 meters.
- Ensure installation conditions are within -20°C to 60°C and that the total pixel count does not exceed 2048 pixels.
Główne cechy i opis
- Addressable LED Compatibility: Supports TTL/SPI signal addressable RGB pixels (WS2811, WS2812B).
- Niezgodne urządzenia: NOT designed for constant voltage PWM LEDs.
- Pilot RF: Includes a 14-key RF wireless remote with approximately 20 meters of range.
- Efekty dynamiczne: Loaded with 358 built-in dynamic lighting effects.
- Pojemność kontrolna: Capable of driving up to 2048 pixels.
- Compact Hardware: Small, high-stability design optimized for space-restricted installations.
Zawiera
- 1 * SP103E Mini Programmable LED Controller
- 1 * 14Keys RF Remote
- 1 * Instrukcja obsługi
Rozwiązywanie problemów
- No/incorrect lighting effects: Confirm you are using addressable RGB pixels that match the supported ICs (WS2811, WS2812B) and use TTL/SPI signaling.
- Controller not responding to the remote: Check that you are within the RF remote range (approximately 20 meters).
- Effects are unstable or not working as expected: Sprawdź objętość wejściowątage is DC 5–24V and that the operating temperature is within -20°C to 60°C.
- Pixels not lighting fully: Ensure the total number of pixels does not exceed the controller’s capacity (up to 2048 pixels).
- Using wrong LED type: The controller is not designed for constant voltage PWM LEDs; switch to compatible addressable pixels.
Dokumenty / Zasoby
 | SP103E LED Magic Controller |
Odniesienia
- Instrukcja obsługimanual.tools
Published: July 16, 2026