Instrukcja obsługi pilota ANDERIC RRTX00I

Wstęp

This manual provides comprehensive instructions for the setup, operation, and troubleshooting of your ANDERIC RRTX00I remote control. Please read this manual carefully before use to ensure proper functionality and longevity of your device.

Rycina 1: Przód view of the ANDERIC RRTX00I Remote Control.

Informacje o zgodności

The ANDERIC RRTX00I remote is designed as a direct replacement for specific Harbor Breeze ceiling fan remotes. It is crucial to verify compatibility to ensure proper operation.

Figure 2: Compatibility chart. This remote replaces models with FCC ID A25-TX00I, TR258A, and KUJCE10512. It is not compatible with A25-TX001-R1 or A25-TX001-R.

Please confirm your original remote's FCC ID matches A25-TX00I, TR258A, or KUJCE10512. This information is typically found on the back of your original remote or inside the battery compartment.

Organizować coś

Instalacja baterii

This remote requires one 12-volt battery (sold separately) to be installed. Ensure polarities match the diagram located inside the battery compartment.

Rysunek 3: Strona view of the remote, showing the battery compartment area.

Instrukcje parowania

1. Turn power to the fan off, either by using the wall switch or the circuit breaker.
   

   Rysunek 4: Example of a wall switch.
2. Return power to the fan.
3. Within 30 seconds of restoring power, press the UCZYĆ SIĘ key located inside the battery compartment of the remote.
   

   Figure 5: Location of the LEARN button inside the battery compartment.

4. The indicator light on the remote will flash. If paired successfully, the fan will turn on to a low speed, and the light will be off.

Ważna uwaga: You cannot program two remotes to the same receiver or fan. Ceiling fans typically do not support this functionality, allowing only one remote to be paired at a time.

Instrukcja obsługi

The ANDERIC RRTX00I remote control features several buttons for controlling your ceiling fan and light:

• Keys (1), (2), (3): When pressed, these keys adjust the fan's speed.
• Key (4): When pressed, this key turns off the fan's motor.
• Key (5): Press and release immediately to turn on/off the light. Press and hold to cycle light dimming.
• Toggle switch D/CFL (6): Slide the switch according to the light bulb(s) installed (Dimming or Compact Fluorescent Light).

Konserwacja

Aby zapewnić optymalną wydajność i długą żywotność pilota, należy przestrzegać poniższych wskazówek dotyczących konserwacji:

• Czyszczenie: Wipe the remote with a soft, dry cloth. Avoid using abrasive cleaners or solvents, which can damage the surface.
• Wymiana baterii: Replace the 12-volt battery when the remote's performance degrades or the indicator light does not respond. Ensure correct polarity during installation.
• Składowanie: Przechowuj pilota w chłodnym, suchym miejscu, z dala od bezpośredniego światła słonecznego i ekstremalnych temperatur, jeśli nie używasz go przez dłuższy czas.
• Obsługiwanie: Avoid dropping the remote or exposing it to excessive moisture, as this can cause internal damage.

Rozwiązywanie problemów

If you encounter issues with your ANDERIC RRTX00I remote control, please refer to the following common problems and solutions:

Brak synchronizacji zdalnej

If the remote fails to sync with your ceiling fan, consider the following:

• Incorrect Remote Model: Verify that you have purchased the correct remote model. The RRTX00I is specifically designed for Harbor Breeze remotes with FCC IDs A25-TX00I, TR258A, and KUJCE10512. Remotes with FCC IDs like A25-TX001-R1 or A25-TX001-R are not compatible as they operate on a different frequency. Check the FCC ID on your original remote (if available) or the fan's receiver.
• Dead Receiver/Fan: If the remote model is correct and it still won't sync, the receiver unit within your ceiling fan might be faulty or "dead." A non-functional receiver will prevent any remote from pairing or operating the fan. In such cases, the original receiver is no longer available, and you may need to purchase a new ceiling fan receiver/remote kit.
• Problemy z baterią: Ensure the 12-volt battery is correctly installed with the right polarity and is not depleted.
• Chronometraż: Ensure you press the LEARN button within 30 seconds of restoring power to the fan.

Official Troubleshooting Video

Specyfikacje

Gwarancja i wsparcie

Aby uzyskać informacje dotyczące gwarancji lub pomocy technicznej, zapoznaj się z oficjalną instrukcją producenta webOdwiedź witrynę lub skontaktuj się z działem obsługi klienta. Zachowaj paragon jako dowód zakupu na wypadek roszczeń gwarancyjnych.

Producent: ANDERIC

Odwiedź Anderic Store on Amazon Więcej produktów i informacji.