Amewi Stingray Speedboat (Model 26108) Instruction Manual

1. Ważne informacje dotyczące bezpieczeństwa

Ostrzeżenie: This product is not suitable for children under 3 years due to small parts that could be swallowed, posing a choking hazard.

• Always operate the speedboat in open water areas, away from swimmers, animals, and other watercraft.
• Ensure the operating area is clear of obstacles such as weeds, rocks, or debris that could interfere with the jet drive.
• Do not operate the boat in saltwater, as this can damage internal components.
• Keep fingers and loose clothing away from the jet drive intake and outlet during operation.
• Always remove the battery from the boat and the transmitter when not in use.
• Nadzoruj dzieci podczas operacji.

2. Co znajduje się w pudełku

Proszę sprawdzić zawartość przesyłki na poniższej liście:

• Amewi Stingray Speedboat Model
• Pilot zdalnego sterowania 2.4GHz
• Li-ion 2S 7.4V 2000mAh 15C Battery
• Kabel ładujący USB
• Narzędzie
• Stojak na łódkę
• Instrukcja obsługi (ten dokument)

Wymagane akcesoria (brak w zestawie): 3 x 1.5V AA batteries for the remote control.

3. Przewodnik konfiguracji

3.1. Ładowanie akumulatora łodzi

The included Li-ion 2S 7.4V 2000mAh battery powers the speedboat.

1. Podłącz akumulator litowo-jonowy do kabla ładującego USB.
2. Podłącz kabel ładujący USB do odpowiedniego źródła zasilania USB (np. portu USB komputera, zasilacza ściennego USB).
3. Wskaźnik ładowania na kablu USB pokaże stan ładowania (patrz informacje na temat zachowania wskaźnika konkretnej ładowarki).
4. Charging typically takes 90-120 minutes. Do not overcharge the battery.
5. Po całkowitym naładowaniu odłącz akumulator od ładowarki.

Image: Internal components of the speedboat, including the battery and motor assembly.

3.2. Instalacja baterii nadajnika

The 2.4GHz remote control requires 3 x 1.5V AA batteries (not included).

1. Otwórz komorę baterii znajdującą się z tyłu pilota.
2. Włóż 3 baterie AA, zwracając uwagę na prawidłową polaryzację (+/-).
3. Dokładnie zamknij komorę baterii.

Image: The 2.4GHz remote control for the speedboat.

3.3. Preparing the Speedboat

1. Carefully remove the top hull cover(s) of the speedboat. The boat features a double hull cover for water protection.
2. Connect the fully charged Li-ion battery to the boat's power connector.
3. Carefully place the battery inside the hull, ensuring wires are not pinched.
4. Securely reattach both hull covers to prevent water ingress. Ensure all latches or seals are properly engaged.

Obraz: Góra view of the speedboat, showing the double hull cover design.

4. Instrukcja obsługi

4.1. Włączanie i parowanie

1. Place the speedboat gently into the water. The boat's electronics will activate upon contact with water.
2. Turn on the remote control. The remote control and boat should automatically pair. A successful pairing is usually indicated by a solid light on both devices.
3. Jeśli parowanie się nie powiedzie, wyłącz oba urządzenia i powtórz proces.

4.2. Podstawowe sterowanie

• Spust przepustnicy: Pull the trigger to move forward, push to reverse (if applicable). The jet drive provides strong acceleration.
• Kierownica: Turn the wheel left or right to steer the boat. The thrust vector control allows for high agility and maneuverability.
• Regulacja trymu: Use the trim buttons on the remote control to fine-tune steering and throttle for straight running.
• Rash Limitation (Dual Rate): Adjust the sensitivity of the steering and throttle for different driving styles or conditions.

Obraz: Tył view of the speedboat, highlighting the jet drive mechanism.

4.3. Zaawansowane funkcje

• Switchable LED Lighting: The boat features front and rear LED lighting, which can be switched on/off via the transmitter. This is useful for operation at dusk.
• Objętość poniżejtage Ostrzeżenie: The 2.4GHz transmitter system includes an undervoltage warning function to prevent the boat battery from being discharged too deeply. Pay attention to audible or visual warnings from the transmitter.
• Ostrzeżenie dotyczące zasięgu: The transmitter will alert you if the boat is approaching or exceeding its maximum operating range (60-80 meters). Bring the boat closer immediately if this warning activates.
• Funkcja samonaprawiająca: In case of a rollover, the boat is designed to self-right, allowing it to continue operation without manual intervention.

The Amewi Stingray Speedboat can reach speeds of up to 40 km/h and offers a driving time of up to 12 minutes on a full charge.

5. Konserwacja

• Po każdym użyciu:
  • Remove the boat from the water and immediately disconnect the battery.
  • Open the hull covers and carefully drain any accumulated water. Wipe the interior dry with a soft cloth.
  • Inspect the jet drive intake for any debris (weeds, leaves, etc.) and remove them carefully.
  • Clean the exterior of the boat with a damp płótno. Nie używaj ostrych chemikaliów.
  • Ensure the water cooling system's inlet and outlet are clear.
• Pielęgnacja baterii:
  • Store Li-ion batteries in a cool, dry place, away from direct sunlight and extreme temperatures.
  • Do not store batteries fully charged or fully discharged for extended periods. Aim for a storage charge of around 50%.
• Hull Seals: Regularly inspect the rubber seals around the hull covers for any signs of wear or damage. Damaged seals can lead to water ingress.

6. Rozwiązywanie Problemów

7. Specyfikacje

8. Gwarancja i wsparcie

For warranty information, technical support, or replacement parts, please contact your retailer or the manufacturer directly. Keep your proof of purchase for warranty claims.

Producent: Amewi