1. Wprowadzenie
This manual provides essential information for the safe operation, maintenance, and troubleshooting of your Powerhorse High-Wheeled Walk-Behind String Trimmer. Please read this manual thoroughly before operating the machine to ensure proper use and to prevent injury or damage.

Figure 1: Powerhorse High-Wheeled Walk-Behind String Trimmer. This image shows the complete assembly of the string trimmer, highlighting its high wheels, engine, and cutting head with orange trimmer lines.
2. Ważne informacje dotyczące bezpieczeństwa
Zawsze przestrzegaj podstawowych zasad bezpieczeństwa, aby zmniejszyć ryzyko pożaru, porażenia prądem i obrażeń ciała. Zachowaj tę instrukcję do wykorzystania w przyszłości.
- Przeczytaj instrukcję: Przed rozpoczęciem użytkowania należy zapoznać się ze wszystkimi instrukcjami i ostrzeżeniami.
- Środki ochrony osobistej (PPE): Always wear eye protection, hearing protection, long pants, and sturdy footwear.
- Bezpieczeństwo paliwa: Handle gasoline with extreme care. Store fuel in an approved container in a well-ventilated area away from ignition sources. Never refuel a hot engine.
- Wyczyść obszar roboczy: Ensure the area is clear of debris, rocks, and other objects that could be thrown by the trimmer line. Keep bystanders, children, and pets at a safe distance.
- Ciepło silnika: The engine and muffler become very hot during operation and can cause burns. Allow the engine to cool before touching or performing maintenance.
- Sprawdź przed użyciem: Check the fuel line for tears or damage before each use, as noted in customer feedback. Ensure all fasteners are tight and guards are in place.
- Prawidłowa obsługa: Operate the trimmer only in well-ventilated areas. Do not operate in wet conditions.
3. Cechy i komponenty produktu
The Powerhorse High-Wheeled Walk-Behind String Trimmer is designed for efficient clearing of weeds, grass, and brush.
Główne cechy:
- Dependable Powerhorse 173cc vertical gas engine with recoil start delivers 3000 max. RPM.
- Offset head design delivers a 22-inch wide cutting swath.
- Rear wheels offer easy maneuverability and walk-behind control.
- Lightweight design is easy to operate, reducing fatigue.
Główne składniki:
- Silnik: 173cc 4-cycle gas engine.
- Głowica tnąca: Equipped with a 22-inch cutting swath for efficient clearing.
- High Wheels: Large rear wheels for improved maneuverability over rough terrain.
- Kierownica: Ergonomiczna konstrukcja zapewniająca wygodną obsługę.

Figure 2: Powerful Performance. This image illustrates the trimmer in action, highlighting its 173cc 4-cycle gas engine and 3,000 max. RPM capability, with a user operating it in tall grass.

Figure 3: Quick and Efficient Cutting. This image shows the trimmer's 22-inch wide cutting swath, demonstrating its ability to clear large areas quickly.

Figure 4: Effortless Walk-Behind Design. This image focuses on the 14-inch rear tires, emphasizing the trimmer's smooth rolling and easy maneuverability.

Figure 5: Lightweight Construction. This image shows the trimmer being operated from the side, illustrating its lightweight design that makes it easy to operate and maneuver, reducing user fatigue.
4. Instalacja i montaż
Your Powerhorse String Trimmer requires some assembly and preparation before first use.
4.1 Rozpakowanie i wstępna kontrola:
- Ostrożnie wyjąć wszystkie elementy z opakowania.
- Inspect for any shipping damage. If damaged, contact customer support immediately.
- Verify all parts are present according to the packing list. The unit typically includes a 16.9-oz. bottle of oil, spark plug wrench, oil funnel, and a 10-pack of trimmer lines.

Figure 6: Fully Equipped. This image displays the trimmer along with its included accessories: a bottle of oil, a spark plug wrench, an oil funnel, and a pack of trimmer lines.

Figure 7: Included Accessories. A closer view of the 16.9 fl. oz. (500 ml) bottle of Powerhorse Premium 4-Cycle Small Engine Lubricant, a spark plug wrench, an oil funnel, and a bundle of orange trimmer lines.
4.2 Handlebar Assembly:
Attach the handlebar to the main unit using the provided hardware. Ensure all bolts are securely tightened.
4.3 Adding Engine Oil:
- Umieść trymer na płaskiej powierzchni.
- Zdejmij korek wlewu oleju/wskaźnik poziomu oleju.
- Using the provided funnel, slowly add the recommended 4-cycle engine oil (e.g., 10W-40) up to the "FULL" mark on the dipstick. Do not overfill.
- Dokładnie załóż korek wlewu oleju.
4.4 Adding Fuel:
- Upewnij się, że silnik jest chłodny.
- Use fresh, clean unleaded gasoline with an octane rating of 87 or higher.
- Ostrożnie zdejmij korek wlewu paliwa.
- Fill the fuel tank, leaving a small space for expansion. Do not overfill.
- Dokładnie zakręć korek wlewu paliwa. Natychmiast wytrzyj rozlane paliwo.
- Ważny: Before filling the gas tank, inspect the fuel line from the gas tank to the engine for any tears or damage. Replace if necessary.
5. Działanie
5.1 Uruchamianie silnika:
- Ensure the trimmer is on a level surface and the area is clear.
- Ustaw wyłącznik silnika w pozycji „ON”.
- Przesuń dźwignię ssania do pozycji „CHOKE” (w przypadku zimnych rozruchów).
- Pull the recoil starter handle firmly and smoothly until the engine starts. You may need to pull several times.
- Po uruchomieniu silnika stopniowo przesuwaj dźwignię ssania do pozycji „RUN”.
- Przed rozpoczęciem pracy należy odczekać chwilę, aż silnik się rozgrzeje.
5.2 Operating the Trimmer:
- Push the trimmer forward slowly, allowing the trimmer line to cut through vegetation.
- Maintain a steady pace. Do not force the trimmer through dense growth.
- Use a sweeping motion for best results.
- Be aware of the 22-inch cutting swath and plan your passes accordingly.
5.3 Zatrzymywanie silnika:
- Zwolnij dźwignię sterującą.
- Przesuń wyłącznik silnika do pozycji „WYŁ”.
- Allow the engine to cool before storage or maintenance.
6. Konserwacja
Regularna konserwacja zapewnia optymalną wydajność i wydłuża żywotność Twojej podkaszarki.
6.1 Po każdym użyciu:
- Wyczyść zewnętrzną część trymera za pomocąamp cloth. Remove any grass clippings or debris from the cutting head and engine cooling fins.
- Check the trimmer line for wear and replace if necessary.

Figure 8: Trimmer Cutting Head. This image provides an underside view of the trimmer's cutting head, showing the trimmer lines and the protective guard, useful for maintenance and line replacement.
6.2 Engine Maintenance:
- Wymiana oleju: Wymień olej silnikowy po pierwszych 5 godzinach pracy, a następnie co 25 godzin lub raz w roku, w zależności od tego, co nastąpi wcześniej.
- Świeca: Inspect and clean the spark plug annually or every 50 hours. Replace if electrodes are worn or fouled.
- Filtr powietrza: Regularnie czyść filtr powietrza, szczególnie w warunkach dużego zapylenia. Wymień go, jeśli jest uszkodzony.
6.3 Przechowywanie:
- For long-term storage, drain the fuel tank or add a fuel stabilizer.
- Dokładnie wyczyść trymer.
- Przechowywać w czystym, suchym i dobrze wentylowanym miejscu, z dala od bezpośredniego światła słonecznego i ekstremalnych temperatur.
7. Rozwiązywanie Problemów
W tej sekcji znajdziesz informacje o typowych problemach i ich potencjalnych rozwiązaniach.
| Problem | Możliwa przyczyna | Rozwiązanie |
|---|---|---|
| Engine will not start or is difficult to start. | No fuel, stale fuel, incorrect choke setting, fouled spark plug, fuel line issue. | Check fuel level and quality. Adjust choke. Inspect and clean/replace spark plug. Inspect fuel line for tears or blockages. |
| Silnik pracuje słabo lub ma za mało mocy. | Dirty air filter, incorrect fuel mixture, old fuel, spark plug issue. | Clean/replace air filter. Use fresh fuel. Check spark plug. |
| Trimmer line not cutting effectively. | Worn or incorrect trimmer line, debris in cutting head. | Replace trimmer line with recommended type (4mm x 4mm square). Clear debris from cutting head. |
| Nadmierne wibracje. | Luźne elementy, uszkodzona głowica tnąca. | Check all fasteners for tightness. Inspect cutting head for damage. |
8. Specyfikacje techniczne
| Specyfikacja | Szczegół |
|---|---|
| Marka | Koń pociągowy |
| Numer modelu | DMT56-DV173 |
| Typ silnika | 173cc 4-Cycle Gas Engine |
| Maksymalne obroty | 3000 |
| Szerokość cięcia | 22 cali |
| Tryb działania | Manual, Walk-Behind |
| Waga przedmiotu | 77.5 funtów |
| Wymiary produktu | 30.31 x 19.3 x 5 cala |
| Tworzywo | Metal |
| UPC | 840321751157 |
9. Gwarancja i obsługa klienta
Powerhorse products are manufactured to high-quality standards. For specific warranty details, please refer to the warranty card included with your product or visit the official Powerhorse webstrona.
For technical assistance, parts, or service, please contact Powerhorse customer support. Contact information can typically be found on the product packaging or the manufacturer's webstrona.
Notatka: This item is subject to hazardous materials regulation for transportation and may have specific return policies. Please consult your retailer for details.