1. Koniec produktuview
The Foset 49491 REGEL-4 Electric Shower Head provides instant hot water with four adjustable temperature levels. Designed for various installations, it includes a hand shower head with a 5 ft hose for enhanced convenience. This unit is ideal for homes, apartments, campsites, or cabins where instant hot water is desired.
Główne cechy:
- 4 poziomów temperatury: Cold, Warm, Hot, Very Hot.
- Natychmiastowa ciepła woda: Heats water on demand.
- Automatyczny czujnik włączania/wyłączania: Activates when water flows and shuts off when water stops.
- Trwała konstrukcja: Made from high-impact polypropylene.
- Kompaktowa konstrukcja: 6-inch shower head diameter.
- Dołączone akcesoria: Hand shower head with 5 ft hose.
Składniki:
Familiarize yourself with the main components of your electric shower head.
Figure 1: Main components of the Foset Electric Shower Head.
2. Instalacja i konfiguracja
Proper installation is crucial for the safe and efficient operation of your electric shower head. It is highly recommended to have a qualified electrician perform the electrical installation.
Wymagania elektryczne:
- Tomtage: 127 V.
- Minimalna pojemność: 50 A breaker.
- Przekrój drutu: Use 10 AWG for distances less than 30 ft (10 meters) and 8 AWG for distances greater than 30 ft (10 meters).
- Obwód dedykowany: Connect directly to the load center with an independent connection.
- Grunt: Ensure a proper physical ground connection (green/yellow wire) for safety.
- Ostrzeżenie dotyczące bezpieczeństwa: Do not use plugs, adapters, or extension cords.
Ciśnienie wody:
The height of the water tank should be between 3 to 33 ft (1 to 10 meters) from the shower head. If the water pressure is low, a reducer (not included, e.g., Truper 49494 - BRA-REGEL) may be required to ensure proper operation and heating.
Montowanie:
The shower arm is not included and must be purchased separately. The unit is designed for wall-mounted installation.
Figure 2: Electrical Installation Diagram.
3. Instrukcja obsługi
The Foset Electric Shower Head is designed for simple operation with an automatic water flow sensor and adjustable temperature settings.
Wybór temperatury:
The shower head features a selector switch to choose one of four temperature levels:
- Zimno: For unheated water.
- Ciepły: For moderately heated water.
- Gorący: For standard hot water.
- Bardzo gorąco: For maximum heating.
Adjust the selector to your desired temperature before turning on the water. The unit will automatically activate when water flows through it.
Figure 3: Temperature Level Indicators.
4. Konserwacja
The Foset Electric Shower Head is designed for durability and minimal maintenance. The heating element is galvanized to resist corrosion from water, even if it contains salt or impurities.
Czyszczenie:
- Periodically clean the shower head nozzles to prevent mineral buildup.
- Use a soft cloth and mild soap for cleaning the exterior. Avoid abrasive cleaners.
Element grzewczy:
The internal heating element is designed for longevity. If the unit stops heating water, it may indicate an issue with the heating element or electrical supply. Consult a qualified technician for inspection and replacement if necessary.
5. Rozwiązywanie Problemów
If you encounter issues with your Foset Electric Shower Head, refer to the following common problems and solutions:
| Problem | Możliwa przyczyna | Rozwiązanie |
|---|---|---|
| Brak ciepłej wody | No power to the unit; temperature selector set to 'Cold'; insufficient water flow to activate sensor; faulty heating element. | Check circuit breaker; ensure temperature selector is on 'Warm', 'Hot', or 'Very Hot'; ensure adequate water pressure; consult technician for element check. |
| Woda nie jest wystarczająco gorąca | Temperature selector set too low; high water flow rate; low incoming water temperature. | Increase temperature setting; reduce water flow rate; ensure water tank height is within recommended range. |
| Woda wycieka z urządzenia | Improper installation/seal; damaged unit. | Ensure all connections are tight and properly sealed; inspect unit for cracks or damage. If damaged, replace the unit. |
| Wyzwolenia wyłącznika | Overload on the circuit; incorrect wire gauge; faulty unit. | Ensure dedicated circuit with correct amperage (50A minimum); verify wire gauge (10 AWG for <30ft, 8 AWG for >30ft); consult a qualified electrician. |
| Electric shock sensation | Nieprawidłowe lub brakujące połączenie uziemiające. | Natychmiast przerwać stosowanie. Have a qualified electrician inspect and correct the grounding system. The internal earth wire is designed to mitigate this risk, but a proper external ground is essential. |
6. Specyfikacje
| Funkcja | Szczegół |
|---|---|
| Marka | Foset |
| Numer modelu | REGEL-4 (49491) |
| Styl | Instalacja wewnętrzna |
| Kształt | Okrągły |
| Tworzywo | High-impact polypropylene (Plastic) |
| Rodzaj wykończenia | Namalowany |
| Typ instalacji | Montaż na ścianie |
| Kolor | Biały |
| Wymiary produktu | 5" dł. x 4.7" szer. (ok. 12.7 cm dł. x 11.9 cm szer.) |
| Średnica głowicy prysznicowej | 6 cali (ok. 15.2 cm) |
| Liczba ustawień | 4 (Cold, Warm, Hot, Very Hot) |
| Liczba dysz | 1 |
| Źródło zasilania | Elektryczny przewodowy |
| Waga przedmiotu | 1.32 funta (ok. 0.6 kg) |
| Długość węża | 5 stóp (ok. 1.5 metrów) |
| Producent | TRUPER |
Figure 4: Shower Head Diameter.
7. Gwarancja i wsparcie
Specific warranty information and customer support contact details are not provided in this manual. Please refer to the product packaging or the manufacturer's official website for the most up-to-date warranty terms and support options.